ASSEMBLER

The Seats Assembler I ensures that assembling requirements are fulfilled in accordance with the production instructions received, assembles the product in accordance with approved procedures and assembly instructions. Verifies that materials used, and the assembled part meets product and process specifications. The Assembler works under the direct supervision of a Lead Assembler and/or Production Supervisor to satisfy work assignments. 

•    Observe good housekeeping and safety procedures and keep equipment, tools, and work area clean and orderly by performing 5-S duties and continued dedication to raising the bar.
•    Exhibit teamwork in all you do, maintaining a positive and team-based attitude.
•    Support peers in time of high demand by working hours assigned and overtime as required; also comply with scheduled start/stop times and break periods for the facility.
•    Required to wear personal protective equipment where applicable.
•    Finishing Operation: Verify quality of the sub-assembly and proceed to finish. Verify units built meet the product/customer specifications as required.
•    Notify the Area Supervisor or Quality Inspector/Engineer if non-conforming equipment is detected.
•    Identify the suspected non-conforming part to prevent further use of it.
Follow and use Job Travelers, routing, and shop instructions. Document all operations as required.
•    Perform assigned functions from oral and/or written instructions, drawings, or other manufacturing.
•    Follow established procedures/work instructions for assigned function and handle materials in accordance with established procedures.
•    Maintain expected progress of jobs in area of assignment and communicate problem areas or parts shortages.

Qualifications:

Required:

•    Must be a US Citizen
•    Must have a High School diploma or GED
•    General Knowledge of operating hand tools, portable power tools, and bench tools
•    Strong attention to detail, quality-focused, and willing to learn
•    Excellent communication skills
•    Basic computer skills and the ability to operate computer terminals and general software applications
•    Ability to stoop, kneel, crouch, reach, walk, push, pull, and grasp
•    Ability to stand/sit for sustained periods of time
•    Able and willing to lift 50 pounds frequently from the floor to tabletops, throughout the work shift
•    Willingness to work flexible hours such as overtime
•    The position may be required to work weekends, evenings, and/or holidays, based on the needs of the organization.

Preferred:

•    Minimum one year of experience in mechanical assembly OR manufacturing setting is preferred but not necessary
•    Ability to read engineering drawings, schematics, and blueprints desired